DE | EN

Electric gear pump EP 300-DS

self priming gear pump with 3 m cable for mains connection,

equipped with pressure-switch control and pressure-relief device

fluids according hazard class A3 with a flash point higher than 55° C

output: approx. 22 l/min. (SAE30 at free delivery)

max. pressure: approx. 8 bar, suction height up to 2,5 m

electric data: 230V, 50Hz, 2.8A, 0.37kW, IP55

threads: 3/4" (outlet) / 1" (inlet)

Operating advice:

The self-priming electric EP gear-wheel pumps are designed to transfer and dispense oil. An

integrated bypass-valve limits the max. oil pressure, the pumps are pressure-switch controlled.

When the filling gun is closed (pressure builds up), the pump switches off, when the filling

gun is opened (pressure decrease) , the pump starts to run. Additionally, the pumps come with

a pressure relief device (Art.-No. 34 336 97), which reduces oil pressure inside the system

when pumps stand idle, and allow to vent trapped air, i.e. after drum change. After operation

(end of shift) the pumps must be switched off and separated from the mains supply.

EP 300-DS is suitable for use with engine, gear and hydraulic oils from low to moderate viscosity.

It is not supposed to be used with hose reels and/or set-ups of long oil promotion distances.

Please consider that hose and tube diameter, changes in flow direction , promotion distances,

oil viscosity and ambient temperatures significantly determine the system's flowrate. In case of

doubt please consult with MATO.

  • Article: 3434038
  • Tarif-No.: 84136039
  • MPQ: 1,00
  • Unit pcs.: Stück
  • Weight: 12,5
  • GTIN: 4016553434038