self priming gear pump with 3 m mains cable for mains connection,

integrated by-pass pressure regulator and protected on/off switch,

for use at increased flow resitance and/or long oil promotion distance,

for engine, gear and hydraulic oils of higher viscosity,

offers high pressure performance at moderate flow rate

for fluids Hazard Class A3 with a flash point higher than 55° C

threads: R3/4" (outlet) / R1" (inlet)

output: approx. 11 l/min. (SAE30 at free delivery)

max. pressure: approx. 16 bar, suction height up to 2,5 m

electric data: 230V, 50Hz, 5.3A, 0.75kW, IP55

Operating advice:

The self-priming electrig gear-wheel pumps EP are designed to transfer and dispense oil.

An integrated bypass-valve limits the max. oil pressure. The pumps feature a protected

switch and must be shut off after operation. Do not let the pumps run more than 5 minutes

in by-pass mode against the closed dispense nozzle. If required, the pump can be upgraded

with a pressure relieve device (Art.-Nr. 34 336 97).

EP 200 and EP 400 are suitable for use with engine, gear and hydraulic oils from low to

high viscosity. The achievable pressure rate of 16 bar allows their use with hose reels

and/or set-ups of long oil promotion distances.